南水北调东平湖水质变化趋势分析研究

采用了季节性肯达尔法水质趋势分析方法,分析了1984～2000年东平湖水质的变化情况,目前东平湖水质一般为Ⅴ类、Ⅵ类,个别年份为超Ⅴ类,氨氮平均值历年变化不大,一般均符合Ⅰ Ⅲ类水质,挥发酚和砷含量甚小,各年均符合Ⅰ类水。     

焦作市区大气污染状况与防治措施

根据“九五”期间焦作市区的大气污染监测资料，对市区大气污染状况进行了分析和评价，并对其成因进行了分析，提出了一些具体的防治措施。     

平顶山市湛河水污染现状及防治对策

以“九五”期间平顶山市湛河水质例行监测结果为依据，分析了湛河水污染现状、特征及原因，并提出综合性湛河污染防治对策。     

石河子市空气污染成因及防治对策

对石河子市空气环境质量状况进行了评价，对影响石河子市环境质量的主要因素进行了分析，得出石河子市空气污染属煤烟沙尘型，提出了相应的治理措施和建议。     

空气细颗粒物(PM2.5)污染特征及其毒性机制的研究进展

细颗粒物(PM2.5)是指空气动力学直径≤2.5μm的颗粒物,其表面吸附大量的有毒有害物质,并可通过呼吸沉积在肺泡,甚至可通过肺换气到达其他器官.由于细颗粒物的重要性,美国EPA已经于1997年颁布了细颗粒物的空气质量标准,年均值为0.015mg/m3,日均值为0.065mg/m3,然而我国至今仍未制定细颗粒物空气质量标准.颗粒物上吸附的化学组分主要可分成自然来源及燃煤或燃油等人为污染来源两大类,特别是来自工业性和居住区燃煤及汽车燃油尾气.空气细颗粒物污染表现为形态各异、成分复杂等特征.细颗粒物有明显的毒性作用,可引起机体呼吸系统、免疫系统等较为广泛的损害.细颗粒物与心肺疾病密切相关,如增加入院率、急诊次数、呼吸疾病及症状增加、肺功能下降,甚至于过早死亡.简要概述了细颗粒物的污染特征及其毒性机制研究进展.     

我国污染源在线监测现状及建议

文章在对国内重点城市污染源在线监测调查研究的基础上 ,分析总结了国内污染源在线监测的经验和教训 ,提出了推进污染源在线监测的建议     

Biomonitoring heavy metals in estuaries: a field comparison of two brown algae species inhabiting upper estuarine reaches

Biomonitoring dissolved heavy metals within estuaries,particularly at their upper reaches, frequently has to relyon several biomonitors; rarely a single species thrives allalong the salinity gradient. To properly do so, it must beestablished whether those biomonitors actually accumulateheavy metals alike. In this study, two brown seaweeds fromthe upper section of three NW Spain estuaries – the widely-known Fucus vesiculosus and the estuarine Fucusceranoides – were compared as metal biomonitors. Bothspecies were collected at five locations where they eithercoexist or live close to each other and their heavy metalcontent (Cu, Cr, Mn, Zn, Fe, Al) was measured. Analyseswere appropriately replicated for each species x locationcombination to allow a statistically reliable detection ofdifferences in bioaccumulation, with particular emphasis onthe magnitude of interspecific differences. The lack of significant differences for Cu, Mn, and Zncontents in F. ceranoides and F. vesiculosussupports the feasibility of their joint use to monitorthese metals along the estuaries. Conversely, F.ceranoides concentrated significantly higher levels of Cr,Fe, and Al than F. vesiculosus and hence combiningdata for both fucoids to monitor these elements seemsimpractical. The correlation of species differencestogether with a similar Al:Fe ratio in both weed tissue andsediment suggest that Cr, Fe, and Al tissue-burdens mightbe considerably biased by sediment retained on the surfaceof the weed. Parallel analyses of Al and/or Fe in seaweedsand sediments could serve to keep track of thisinterference and may help to combine data from both fucoidsfor monitoring elements like Cr.     

Effect of an industrial discharge on water quality and periphyton structure in a pampeam stream

Seasonal sampling was carried out at four sites on a pampeanstream that receives industrial effluent from two textile factories. To evaluate water quality, several physical and chemical parameters were examined and the periphyton growing oncattail (Typha latifolia L.) were analyzed.Water quality and periphyton structure differed significantlybetween sites upstream and downstream of the discharge. Differences in temperature and also in concentrations of phosphate, dissolved oxygen, and phaeopigment were detected. At the same time, changes in the dominant algae groups wereobserved. Downstream of the industrial discharge, the numberof Bacillariophyta decreased, while species of Cianophyta andEuglenophyta were more abundant. This abundance correlated withincreased phosphate and organic matter content and decreased oxygen concentration. Although this study did not detect a reduction in the number of species, similarity between stands decreased downstream of the industrial discharge. Changes incommunity structure were readily detected in this situation because the communities of the polluted and unpolluted zones were qualitatively different. Periphyton growing naturally on Typha latifolia is a useful indicator of the impact of waste waters on the biota and can also be used to evaluate water body recovery.     

Monitoring atmospheric metal pollution: a review of the use of mosses as indicators

This article reviews the literatureon the use of mosses for monitoring atmospheric metalpollution. It discusses the nature of mosses, themechanisms for moss uptake of metals from the air andwet precipitation, the various forms in which mossesare used for this purpose, and cases in which mosseshave been used for monitoring local hot spots ofpollution, and regional patterns of metal pollution.Also highlighted are the questions of uptake of metalsfrom the substrates, interspecies differences, and acomparison of the effectiveness of mosses with otherindicator materials, among other issues.     

Environmental Impact Assessment of the Mining and Concentration Activities in the Kola Peninsula, Russia by Multidate Remote Sensing

On the Kola Peninsula, the mining and concentration industry exerts anthropogenic impact on the environment. Tailing dumps cause airborne pollution through dusting, and waterborne pollution due to direct dumping and accidental releases. The objectives were: (1) to analyse multidate satellite imagesfor 1964–1996 to assess the environmental pollution from themining and concentration activity in the Kola in temporal perspective; (2) to evaluate remote sensing methods for integrated environmental impact assessment. The area of mining and industrial sites steadily expands and amounted to 94 km² in 1996. The polluted water surface amounted to at least 150 km² through dumping in 1978 and to 106 km² in1986 due to dusting. Thus, the impact from the mining and concentration activity should be reconsidered as more significant than it was officially anticipated. In the past the main mechanism of pollution wasdirect dumping into the lakes. Currently and in future, airborne pollution after dusting storms will dominate. The effective recultivation of the tailing dumps will be a long-term process. For effective assessment of impacts from the mining and concentration industry, remote sensing methods should be complemented by in-situ measurements, fieldwork, and mathematical modelling.